Weld size (nugget diameter) is typically slightly less than the diameter of the impression the electrode creates on the material. These dimensions and other spot welding parameters are given in Table I for aluminum, carbon and stainless steel. For simplicity, such standards can be specified by the designer as the controlling print information on spot welds. Base metal strength and spot weld strength are interrelated. Table I gives realistic strength expectations for design purposes. For economy, avoid over-specification of welds.
Start off by drilling 7.5mm holes in the front sheet of metal at a spacing of normally 25mm to 40mm (or whatever the original spot weld spacing was). Then clamp this sheet onto the back sheet. 7.5mm is a reasonably good hole size for 0.8 or 1.0mm sheet. Thicker sheet might require a slightly larger hole size. Try a little test piece out like this one before welding a whole sill onto a car and check the weld has penetrated through both sheets.
How Does Spot Welding Work? A form of resistance welding, spot welding is one of the oldest welding processes whereby two or more sheets of metal are welded together without the use of any filler material. The process involves applying pressure and heat to the weld area using shaped alloy copper electrodes which convey an electrical current through the weld pieces. The material melts, fusing the parts together at which point the current is turned off, pressure from the electrodes is maintained and the molten “nugget” solidifies to form the joint. Read more details on Tecna Spot Welder Parts.
Electric welding relies on the Joule Effect. This is the thermal result of the electrical resistance, occurring when an electric current passes through a conductive metal – in this case metal sheets for assembly. If that last sentence went over your head, here’s how it works: to weld two or more sheets together without adding a filler metal, they are tightly compressed between two heat-resistant electrodes (i.e. non-melting), generally made of copper, and a high-intensity current is applied to melt the plates together at that point. The result is a small merging of metal which constitutes a welding point. The welding time is very short, between one and two seconds, and the shape of the resulting welding spot depends on your choice of electrodes.